SoundSystem DMX 53
The Playback Window
Here you can set – who would have thought? – the volume of the individual signal sources.
Signs of wear because of frequent use will be the fate of the controller labeled "OUT" – you
can use this to control the entire volume of the system. In addition:
WAV Controls the playback of all audio streams which are played via the DMX
Playback driver.
MIDI 1 Controls the volume of the internal Wavetable synthesizer.
AUX, RADIO
and TAD
Mixes the identified signal paths – detailed information can be found in the
appropriate section of the chapter "Card Connections and their
Applications.".
LINE Controls the playback (not the recording sensitivity) of a line input of a
connected device.
MIC Does the same thing for a connected microphone.
CD Controls the volume of both CD audio inputs.
DIG IN Allows you to decrease the signal strength of digital source and is hidden
when no digital module is connected to the card. This also doesn't control
the recording sensitivity.
All signal sources can be muted by simply pressing the MUTE button. These are still being
recorded when you explicitly select the source - that makes sense, we're in the Playback and
not the Record Window. A muted signal is not recorded when you have selected it as the
recording source "Mix".
The position in the stereo picture is controlled by the higher panoramacontroller.
To Next Page
Loading...
Need help?
General
