SoundSystem DMX 9
Installation.
Thanks to PCI and plug&play technology, the installation of your
SoundSystem DMX shouldn't pose a problem.
If you already have experience with installing hardware and software
components in Windows, you can proceed with the installation of this
card without any worries.
For the professionals who want to get started ASAP, here is a short overview:
· The SoundSystem DMX is a PCI card (as you no doubt have already seen) and should be
installed as far away from graphic cards or SCSI controllers as possible.
· Don't worry: the connecting cable of the digital interface cannot be inserted incorrectly.
· You need 1 IRQ.
· You need a few free address ranges (usually not a problem).
· Driver installation in Windows follows the standard. The drivers can be found on the
enclosed CD-ROM.
· After installing the driver, take a look at the Device Manager and see if there is an
exclamation point. If you see one, there is a problem. Possible solutions can be found in
the appendix (page 70).
· After driver installation, the software installation starts automatically. The ControlPanel
must be installed.
So much for the short version. A detailed, illustrated description of the installation can be
found in the following section.
To Next Page
Loading...
Need help?
General
