70 SoundSystem DMX
Appendix
FAQ – Frequently asked questions and their answers.
Do you have to set jumpers and change switch settings before I install the sound card?
All card functions are plug and play and correspond to Intel/Microsoft specification. There
are no jumpers or switches to be set for IRQs, DMA channels and addresses. You can turn
on the booster using the jumper. This allows you to connect headphones to both card
outputs.
I can't change the IRQ of my DMX in the Device Manager.
PCI cards are controlled by the computer's BIOS. Place the card into another PCI slot. It
should now be assigned another IRQ. If there are no other free PCI slots, you could
exchange the card with another one. If this doesn't help, check with the manufacturer of
your mother board.
Help! There is no sound coming from the sound card.
· Check the connections between the soundcard and speakers.
· Are active speakers or Hifi devices switched on?
· Check the control settings on the DMX ControlPanel. Make sure that Mute is not
activated.
· Make sure that the current driver is installed for the operating system being used.
I don't notice the MacroFX effect.
Check the settings in the DMX Mixer. MacroFX operations with a volume increase. If you set
the controller to max., the card cannot increase the volume any further.
To Next Page
Loading...
Need help?
General
