TESTO 160 TH - Testo 160 IAQ

2 Description of the instrument
10
2.2.5 testo 160 IAQ
You can use the testo 160 IAQ WiFi data logger to carry out
temperature, humidity, carbon dioxide concentration and atmospheric
pressure measurements.
Element Element
1
Status LED
2
Display
3
Air quality light
4
CO
2
sensor
5
QR code
6
Button
7
USB connection
8
Internal sensor for temperature
and relative humidity
If the WiFi data logger is in Continuous Mode (external power supply
via USB mains unit), the air quality light stays on permanently.
Temperature and humidity readings are displayed alternately.
If the WiFi data logger is in Single Mode (without external power supply
via USB mains unit), the air quality light only comes on briefly during
the measurement. Only the temperature is displayed. When switching
to Single Mode, the WiFi data logger does not supply any readings for
at least 10 min. “CAL” is shown on the display until the next
measurement.