TESTO 160 TH - Installing the Probe on the Data Logger; Changing Batteries

4 Operation
31
4.5.1 Installing the probe on the data logger
The external probes must be connected to the WiFi data logger
before
logging into the Cloud for the first time. If an additional probe is to be
connected at a later stage, the data logger must first be logged out of
the Cloud. The external probe can then be connected and the data
logger logged in again.
1
- Connect the probe plug to the
designated jack on the data logger.

The external probe is ready for use.
4.5.2 Changing batteries
A battery change stops a measurement that is currently running.
However, stored data is preserved.
CAUTION
Incorrectly inserted batteries!
The instrument may be damaged!
- Pay attention to the polarity when inserting the batteries.
Only use new branded batteries. If a partially exhausted battery is
inserted, the battery capacity will not be calculated correctly.
1
- Open battery compartment cover.