TESTO 160 TH - Deco-Cover Installation

4 Operation
32
2
- Change batteries. Pay attention to
polarity.
3
- Close the battery compartment.
4.5.3 Deco-cover installation
1
- Break out the required, pre-punched
knock-out points on the deco-cover.
2
- Place the deco-cover onto the data
logger from the side and press it into
place.
3
- Always make sure that the deco-
cover is positioned correctly so as
not to obscure sensors.
4
- Then connect external probes or the
external voltage supply once again.