TESTO 160 TH - Network Analysis; Analysis and Reports (Web)

4 Operation
34
When configuring the WiFi data loggers using the testo Saveris 2 App,
the smartphone functions as a hot-spot and any default hot-spot
settings are changed. After finishing the configuration, these may need
to be adjusted again manually.
ast
4.6.2 Network analysis
Use the network analysis to analyze your WLAN network in advance in order to
check the requirements for operating the testo 160 loggers correctly.
You can also optionally create and send status reports.
4.7 Analysis and reports (web)
According to the settings specified by the user (Report settings),
reports are regularly generated automatically by the system (Generated
reports).
1
- Click on the “Automatic reports” button.
2
-
Enter the data required to create an automatic report.
The following settings can be defined and edited:
• Name of the report: Designation of the automatic report.
• Measuring points for the report: Measuring points that are to be covered in
the report. Click on the checkbox in front of the channel designation.
• How often is the report to be created?: Interval at which the reports are to
be generated. Select a report cycle from the drop-down menu.
• File format: File format in which the reports are to be generated. Select a file
format from the drop-down menu.
• Data views: Data views in which the data in the report is to be displayed.
Click on the checkbox in front of the data view designation.
• Also send report via e-mail: as well as saving reports under Generated
reports, these can also be sent as e-mails. Click on the checkbox to open
the input screen for e-mail addresses.
Only users created with a supplied e-mail address are listed as
possible e-mail recipients. It is not possible to directly input an e-mail
address.
3
- Click on the “Create an automatic report” button.