TESTO 160 TH - Page 24

4 Operation
22
1
- Mount the wall bracket at the
designated location using suitable
mounting materials (screws, cable
ties or the supplied 3M adhesive
strips).
2
- Open battery compartment cover.
3
- Remove battery safety strips.
4
- Close the battery compartment.
5
- Insert the data logger into the wall
bracket.
The IAQ data logger has a higher energy requirement. This reduces the
minimum measuring cycle to 5 minutes when battery-operated.
Operation via mains unit is therefore recommended. An appropriate
USB cable can also be purchased as an accessory.