27
TEXI Catenaccio operation manual
Function Test Code Function Content
Test input signal LED hint switch, sensor input
X/ Y Motor Origin Sensor
Test
Display the statuses of the X/Y motor step motion
operation, origin searching operation and X/Y
origin sensor.
Continuous Running If setting the condition of continuous running, test
the continuous running mode.
Main motor rotation num-
ber test
Setting rotation number, machine start-up ,display
of actual rotation number
Thread-trimming test Action of thread-trimming motor, debugging the
installation of knife
Presser /thread-trimming
motor /origin sensor test
Display the step motion of presser/thread-trimming
motors, operation of origin searching, and the
status of presser origin/presser sensor.
Thread-catching motor/
origin sensor test
Display the step motion of thread-catching motor,
operation of origin searching and the status of
thread-catching origin/thread-catching sensor.
_________________ _________________
11-1. CP-1 Input Signal Test
Test the input status of the buttons, pedal and sensors. Press to have access to CP-1 when the “CP-1” is displayed at
the screen. After that, the screen displays the “1” that means the first test content.
Hint: if press P1& P2 at the same time when you input number, the
inputted number will add 1 and renewed.
Hint: for the input status hint information
of Sewing LED at ON/OFF, please refer to
the below table.
To Next Page
Loading...
Need help?
General
