32
TEXI Catenaccio operation manual
11-6. CP-6 Test Presser Origin Sensor
Display the step motion operation of presser motor, operation of origin search and status of presser origin sensor.
(1). Operation
1. Preparation
Firstly, user can press to have access to CP-6. Then user can press to search the origin of thread-
catching; at this time, the sewing LED is on.
2. Operations
If the user presses for 6 ~ 8 times, and then the display on screen changes to “01” from “00”, it means the presser
sensor is normal. If not, please adjust the position of the presser sensor.
After user presses , the relating parts on the machine will do the 5-step cyclic action in the sequence shown in
above figure. Press to quit that mode.
Status of presser origin sensor: “0” or “1”
By pressing , user can drive the presser motor to each pointed
position:
1. Presser up position
2. Presser down position (lowering position during the operation of pedal);
3. Thread-trimming position
4. Presser down position (lowering position after thread-trimming)
5. Thread-string position
Use 、 to drive the
thread-trimming motor at +/-
direction with the step of pulses.
To Next Page
Loading...
Need help?
General
