Texi Catenaccio User Manual

15
TEXI Catenaccio operation manual
7. Adjusting the thread take-up spring
［5］OPERATION OF THE SEWING MACHINE
1. Settings of Item Data
Please set the items in the following sequence:
(1). Turn ON the power switch.
The pattern number of the item selection is lit up, and the pattern number will be displayed at data display part.
(2). Setting of the pattern No.
(3). Setting of the X scale
The standard stroke of thread take-up spring (1) is 8 to 10 mm,
and the pressure at the start is 0.1 to 0.3N.
1). Adjusting the stroke
Loosen setscrew (2), and turn thread tension asm. (3).
Turning it clockwise will increase the moving amount and
the thread drawing amount will increase.
2). Adjusting the pressure
To change the pressure of the thread take-up spring, insert
a thin screwdriver into the slot of thread tension post (4)
while screw (2) is tightened, and turn it. Turning it clockwise
will increase the pressure of the thread take-up spring.
Turning it counterclockwise will decrease the pressure.
1. Press , and then the LED of will be on.
2. Press and to display 14 in the Data
Display LED
(We take No.14 pattern as an example.)
Refer the pattern No. to the separate table.
Setting of the
pattern No.
Setting of the
X scale
Setting of the
Y scale
Setting of the
max. sewing
speed limitation
Setting End
1. Press , and then the LED of will be
displayed.
2.Press & to display 100 at Data
Display LED
(The Scale Rate in X Direction is set as 100%)
The setting exceeding 100% is dangerous
since needle and the cloth presser interferes
with each other and needle breakage or the
like will occur.

Texi Catenaccio Specifications

General

Brand	Texi
Model	Catenaccio
Category	Sewing Machine
Language	English