Texi Catenaccio User Manual

2
TEXI Catenaccio operation manual
11. Debugging Mode ..............................................................................................................................................
11-1. CP-1 (Input Signal Test) ......................................................................................................................
11-2. CP-2 (Check X/Y Motor/Origin Sensor) ...............................................................................................
11-3. CP-3 (Continuous Running) ................................................................................................................
11-4. CP-4 (Test Main Motor Speed) ............................................................................................................
11-5. CP-5 (Adjustment on Thread-trimming) ...............................................................................................
11-6. CP-6 (Test Presser Origin Sensor) ......................................................................................................
11-7. CP-7 (Test Thread-catching Motor/ Origin Sensor) .............................................................................
12. Parameter Setting .............................................................................................................................................
12-1. Specific Operations on Setting Parameters ...........................................................................................
12-2. Example for Setting Parameters ............................................................................................................
12-3. Table for Parameter Setting ...................................................................................................................
[6] MAINTENANCE ..........................................................................................................................................................
1. Adjusting the height of the needle bar ...............................................................................................................
2. Adjusting the needle-to-shuttle relation .............................................................................................................
3. Adjusting the lift of the work clamp foot .............................................................................................................
4. The moving knife and counter knife ..................................................................................................................
5. Needle thread clamp device ..............................................................................................................................
6. Adjustment of the wiper .....................................................................................................................................
7. Draining waste oil ..............................................................................................................................................
8. Amount of oil supplied to the hook ....................................................................................................................
9. Replenishing the designated places with grease ..............................................................................................
[7] Table of the standard patterns and the standard patterns ..........................................................................................
1. List of Standard Figure ......................................................................................................................................
2. Table of the standard patterns ..........................................................................................................................
[8] Table of the optional parts ..........................................................................................................................................
List of error information ……………………………………………………………………………………………….…………....
Troubles and corrective measures (sewing conditions).....................................................................................................
The System Diagram of the electricity controls..................................................................................................................
25
27
28
29
29
31
32
33
34
34
34
38
40
40
40
41
42
42
43
43
43
44
45
45
49
50
51
52
54

Texi Catenaccio Specifications

General

Brand	Texi
Model	Catenaccio
Category	Sewing Machine
Language	English