4
TEXI Catenaccio operation manual
Danger of injury to operator or service staff
Items requiring special attention
FOR SAFE OPERATION
1. To avoid electrical shock hazards, neither open the cover of the electrical box for the motor nor touch the com-
ponents mounted inside the electrical box.
2. After changing the pattern, make sure the needle entry point. If the pattern is protruded from the work clamp
feet, the needle will interfere with the work clamp feet during sewing, and it is dangerous due to the needle
breakage or the like.
3. Do not turn OFF the power in a state that the needle is lowered. Wiper may break the needle.
1. When nothing is displayed in the operation panel even when the power switch is turned ON, turn OFF the power
switch and check the voltage and the type of the power source.
2. So as to prevent possible accidents caused by abrupt start of the sewing machine, depress the start switch after
ascertaining that there is no interfering thing under the needle when winding the bobbin thread.
3. When turning OFF the power switch, turning ON the ready switch or turning ON the work clamp foot switch, the
work clamp feet automatically come down. So, never place your fingers under the work clamp feet to prevent
possible accidents caused by abrupt start of the sewing machine. During operation, be careful not to allow your
fingers to come close to the work clamp feet.
4. So as to prevent possible accidents caused by the touch of the fingers with the needle, install a finger guard
suitable for each work clamp foot when replacing the work clamp foot.
1 There is the possibility that slight to serious injury or death may be caused.
There is the possibility that injury may be caused by touching moving part.
2 To perform sewing work with safety guard.
To perform sewing work with safety cover.
To perform sewing work with safety protection device.
3 Turn OFF the power and perform “threading”, “replacement of bobbin
or needle”, “cleaning”, “adjustment” and “lubrication”.
To Next Page
Loading...
Need help?
General
