Texi Iris 10 Operation Manual
3
SAFETY RULES
This instruction manual contains important guidelines regarding correct, safe and economical method of use of the
machine. Following recommendations contained in this manual will decrease work down-time, increase machine reliability
and durability, and will make work safer.
This instruction manual must always be available at the workplace. The machine can be serviced only by an employee
trained in Industrial Safety, after reading this instruction manual.
The supplier is not responsible for damages caused by improper use or by usage of this product for functions other than
those it has been designed for.
GENERAL SAFETY PRECAUTIONS
To minimize the risk of fire, electric shock, or injury, observe the following precautions:
- Keep the workplace clean.
- Pay attention to the machine’s work environment; do not subject it to atmospheric conditions.
- Do not install the machine in rooms that are dusty, where aerosols are sprayed, or to which oxygen is supplied.
- Keep the workplace well lit.
- Be careful of danger of electric shock.
- Pay attention to clothing. Let-down hair or loose clothing can be caught by the machine’s mobile elements.
- Take care not to damage the power supply cable.
- When the machine is not in use, disconnect it from the power grid.
- Take care not to turn-on the machine accidentally.
- In case of even the slightest damage, always check if the damaged part requires replacement.
- Never install on the machine attachments and accessories other than those recommended by the manufacturer and
supplier.
- Do not perform machine modifications independently.
- Do not leave near the machine unattended by operators or children.
Electric installation
Check if the supply voltage in the electric socket corresponds to the data on the machine’s rating plate 1-phase voltage
230V 50Hz.
Check the correctness of electric connections in the plug and electric socket, observing electric shock safety counter
measures.
Do not use extension power cords.
Apply the valid electrical and Industrial Safety norms.
ATTENTION – all work related to the electrical installation must be carried out by a qualified electrician.
Before starting work
Using machine without any of the safe guarding parts (finger guard, eye guard, etc.) is dangerous to an operator.
Do not use blunt or bent needles.
Do not touch any of the machine’s mobile elements, such as the needle, needle bar, thread tensioner or take-up, or hook,
during its operation.
To Next Page
Loading...
Need help?
General
