6
01
7
01
Getting Ready I
Safety Advice
Getting Ready I
Safety Advice
Safety Advice
The hardware and software used in products supported by Thinknavi are not guaranteed to perform well under all circumstances.
Use with other hardware or software may cause problems.
Avoid using the product under direct sunlight, as the screen may be dicult to read.
Please use your vehicle’s cigarette jack.
Buttons should not be pressed too hard as this may cause malfunction.
Only press the buttons lightly.
The LCD screen of the product may be damaged if heavy objects are placed on it or it is subjected to impact.
The GPS antenna is an integral part of the product unit.
Do not forcefully raise the GPS antenna.
Adhesives or paint on the GPS antenna or the unit itself may cause malfunction or impair signal reception.
Use only the supplied stylus pen to tap the LCD screen of the product.
Using sharp objects such as nails may damage the product.
Do not use chemicals or cleaners on the product unit.
Wipe it lightly with a soft cloth.
Product
Safety Advice
Do not dismantle the unit or subject it to shock.
In particular, apply sharp objects to the power terminals or the Reset hole.
Keep the product unit and stylus pen out of reach of children.
Animals and children may suer serious injury if they swallow the rubber cap or stylus pen. (Danger of choking or suocation.)
Do not touch the power terminals with wet hands.
Risk of electric shock or malfunction.
Do not use in places with high temperature or humidity.
If the product is used in rain or in a swimming pool, or liquid is spilt over the product, repair may be refused and liability for the damage rests with
the user.
To Next Page
Loading...