10
the OSD Language of your preference. Set the other options as are appropriate for your
situation. HDMI output is always available.TV format with HDMI connection is 16:9 Wide screen.
NOTE If Germany or Italy is selected as country, a pre-installed channel
list is available. German channels from ASTRA 19.2E will be
installed. Italian channels from Hotbird 13E will be installed.
You can continue to Channel search and install further channels as described below or directly
go to viewing mode by pressing OK to start enjoying the pre-installed channels immediately.
4.1 Dish setup
4.1.1 Satellite Selection
Use p/q to highlight the satellite your dish is aimed at. When using a multi feed antenna with
more than 1 LNB, select the satellites your antenna is adjusted for by pressing OK and set the
appropriate LNBs in the right-hand screen by pressing u at the DiSEqC 1.0 or, if applicable,
DiSEqC 1.1 option. The scan process will then search on all selected satellites. If using motorized
antennas or SatCR, please refer to chapter 7.
4.1.2 Signal Adjust
The signal Strength and Quality bar on the bottom of the screen allows you to ne tune the
alignment of your antenna for optimum reception. Adjust your antenna for maximum possible
signal strength and quality. When the signal cannot be improved anymore, x the dish on this
position and press the BLUE button for Scan options and scan.
4.1.3 Scan Mode
Use p/q to highlight the options of choice and press BLUE to start the scan. It is
recommended to use the default settings.
4.1.4 Scan
Your receiver will now perform an automatic channel search. When the process has been
completed, all found channels will be stored and the receiver will switch to the rst found
channel. You are now ready to enjoy your new receiver.
NOTE If no channels were found during the automatic channel scan, the
receiver will return to Installation guide menu. Please select your
language again and refer to chapter 7.3 for further instructions.
To Next Page
Loading...
