THOMSON THS210 - Time and Date Settings

21
English
7.3.2.2 Backup to USB
Press OK to make a backup of the data base. A DBM le „HB_DATABASE_DDMM.DBM” with
the current date (day and month), will be created on the USB device. When the DB has been
successfully stored a message will be displayed on screen. Press  until the OSD menu
disappears.
7.3.2.3 SatCR
If a SatCR LNB is used, please refer to the manual of that LNB to obtain the technical data about
User Bands numbers and corresponding frequencies.
Note: SatCR can only work in combination with an optional multi-output
(max. 8) satellite splitter and a SatCR LNB, example STRONG type
SRT L780 (max. 4 users). Note: SatCR cannot be combined with
any other DiSEqC function. SatCR systems are mainly installed by
professional experts.
SatCR A Select SatCR A with p/q and OK, if you only use one SatCR LNB.
SatCR B When using a two satellite SatCR system, select also the 2nd LNB
and setup as described below.
System Automatic select: Pre-programmed User Bands are installed, refer to
the manual of your LNB to know which system is supported by the
LNB.
IF Channel Manual select: Select the User band ID number according to the
specications of your SatCR LNB. Note: Any SatCR LNB user in the
chain needs a dierent Channel ID number.
Center Freq Manual select: Select the Centre Frequency according to the
specications of your SatCR LNB, corresponding with the correct IF
Channel. Note: Any SatCR LNB user in the chain needs a dierent
Centre Frequency.
Press  to store.
7.4 Time and date settings
Press MENU and select Time. The menu provides options to adjust the time and date settings.
Press p/q to select an option and tu to adjust the setting. Press  to exit the menu.
Time Oset : Select Auto for automatic time and date updates from live signal or
Manual for entering them manually.
Time Zone: Select the Oset from GMT standard time.
Date: Enter the date when Time Oset is set to Manual.
Time: Enter the time when Time Oset is set to Manual.
Auto-Standby This feature is implemented for power saving. The receiver will turn to
Standby automatically if no command from the remote is received for the
selected time period. Default is 3 hours. It can also be turned O.