THOMSON THS210 - Database Management

20
Satellite Name: Press OK to enter text input mode. In the key table select a
character by using the navigation buttons. Press OK to enter the
chosen character. When you have entered the name, navigate to
the “OK” button on screen and press OK on the remote control to
conrm the new name. Save the settings with OK or cancel by .
Edit satellites: Press GREEN to edit the focused satellite. For changing settings see
explanation above. Conrm changes with OK or cancel by .
Delete satellite: Press YELLOW to delete the focused satellite. Press OK to conrm
deleting or  to cancel.
7.3.1.6 Transponder Edit options
Note: Transponders can only be edited when the transponder list is on
screen. To do this, select the satellite you want to edit and press 4
to open the TP list. The options below are now available.
Add transponder: Press RED to add a new transponder. In the pop-up banner, enter
the transponder´s data by using the p/q tu and 0 ~ 9 buttons.
Conrm the settings with OK or cancel with . An existing TP
cannot be stored again under the same satellite.
Edit transponder: Press GREEN to edit the highlighted transponder. In the pop-up
banner, change the transponder´s data by using the navigation and
numeric buttons. Conrm changes with OK or cancel with .
Delete transponder: Press YELLOW to delete the highlighted transponder. Press OK to
conrm or  to cancel.
7.3.2 DB Management
This menu allows you to save and reload the channel Data Base of your receiver from/to a USB-
device. This very convenient feature enables you to save your personal settings like Channel-,
Favourite-, Sat- and TP-lists on an USB storage device and load them back to the receiver later.
This feature is especially helpful after unintentional changes or factory reset. In such cases just
skip the First Installation by pressing  in Installation guide and select the DB management
menu. Connect the USB storage device to you receiver and select one of the options:
7.3.2.1 Load from USB
Press OK for displaying the list with available DB les (if any stored before).
The DB les „HB_DATABASE_DDMM.DBM” are shown with their built date (day and month).
Select the DB le you want to load and conrm it with OK. When the DB has been successfully
loaded (message appears on screen) the receiver will switch automatically to the rst stored
channel and show its content in the background. Press  until the OSD menu disappears.