THOMSON THS210 - Satellite and Transponder Editing

19
English
Blind Scan: Slow scan in 2 MHz steps. The receiver will rst scan the whole frequency
band to nd the transponders it can lock on. After gathering all
transponders, it scans the transponders one by one to get all available
programmes.
NetWork: Network search will be performed – when network information is
broadcast, new transponders will be found and stored.
Scan type: Press tu to select All Channels (scrambled and free) or FTA Channels
(free to air);
Service Type: Press tu to select ALL, DTV or Radio.
After conguring, press OK or BLUE again to start scanning with the selected settings.
Your receiver will now perform an automatic channel search with the scanning progress shown
on screen. During the channel search you can skip transponders by pressing the MENU button,
or quit the scan process with . When the process has been completed, all found channels will
be stored and the receiver will switch to the rst found channel.
Multi-Satellites Scan: When using a multi feed antenna with more than 1 LNB, select
the satellites your antenna is adjusted to with the OK button.
The selected satellites will be marked by the z symbol. Set the
appropriate LNB inputs in the DiSEqC point and press BLUE for
Scan. A window with scanning settings will be displayed. After
conguring the settings like explained in Single Satellite Scan above,
press OK or BLUE again to start Multi-Scan on all selected satellites.
7.3.1.4 Scanning by transponder (Manual Scan)
Press 4 for displaying the transponder list of the highlighted satellite. By pressing Press 4 again
you can switch back to the satellites list.
Single Transponder Scan:
Use the p/q buttons to highlight the transponder you want to
scan and press OK. Press BLUE for Scan. A window with scanning
settings will be displayed. After conguring the settings (explained
in 7.3.1.3 above), press OK or BLUE again to start the scanning
of the highlighted transponder. When the scan process has been
completed, all found channels will be stored and the receiver will
switch to the rst found channel.
Multi-Transponder Scan:
Select the transponders you want to scan with the OK button. The
selected transponders will be marked with the z symbol. Press
BLUE for Scan. A window with scan settings will be displayed. After
conguring the settings like explained in 7.3.1.2 above, press OK or
BLUE again to start Multi-Scan on all selected transponders.
7.3.1.5 Satellite Edit options
Add satellites: Press RED to add a new satellite. In the pop-up banner, enter the
satellite's name and position by using the p/q tu and 0 ~ 9
buttons.