THOMSON THS210 - Channel Search Procedures

16
16:9 Pillarbox For 16:9 TV screens. The unit will display all content in its original aspect
ratio. Programmes formatted in 4:3 will be presented with black bars on
the left and right.
4:3 Letterbox For 4:3 TV screens. The unit will display all content in its original aspect
ratio. Programmes formatted in 16:9 will be presented with black bars on
the top and bottom.
4:3 Pan&Scan For 4:3 TV screens.16:9 content will have the extreme left and right
portions cut o and presented full screen.
TIP You can change the video output format directly from viewing
mode by pressing the YELLOW button on the remote control.
Resolution
If the video does not appear correctly, change the setting. These settings match the most
common settings for HDMI.
1. 480i: for NTSC system TV.
2. 480p: for NTSC system TV.
3. 576i: for PAL system TV.
4. 576p: for PAL system TV.
5. 720p: for NTSC or PAL system TV.
6. 1080i: for NTSC or PAL system TV.
7. 1080p: for NTSC or PAL system TV.
TIP You can change the video resolution directly from viewing mode
by pressing the GREEN button on the remote control.
TV Format
Set the standard corresponding to your TV set. Available options are: PAL and NTSC.
Video Output
This setting is only relevant when the receiver is connected to the TV set via Scart. Select RGB
for the best picture quality or CVBS if your TV doesn’t support RGB.
7.3 Channel Search
To access the menu press MENU and select Channel Search. It contains two options: Dish setup
and DB (Data Base) Management. Select an option and press OK to enter it. Press  to exit the
menu.