5
English
NOTE Indicates any other additional important or helpful information.
MENU Represents a button on the remote control or the receiver. (Bold
characters)
Move to Represents a menu item within a window. (Italic characters)
1.4 Accessories
- 1x installation instructions
- 1x remote control
- 2x batteries (AAA type)
- 1x power adapter 12 V DC, 1.5 A
NOTE: The batteries should not be recharged, disassembled, electrically
short-circuited or be mixed or used with other types of batteries.
If rechargeable accumulators instead of batteries are going to
be used, we recommend using (e.g. NiMH) types with low self-
discharge to ensure long time operation of remote control.
NOTE: For the appropriate usage with this device, use only power
adapters as listed below (in case of a necessary exchange):
- Model: CH-AS120150E7xR; Manufacturer: Sichuan Changhong
Electronic Component Co., Ltd.
- Model: TB-AS120150E6xR; Manufacturer: Ten Pao Electronics
(Huizhou) Co., Ltd.
- Model: CY-AS120150E5xR; Manufacturer: Jiangsu Chenyang Electron
Co., Ltd.
The usage of other power adapters may cause damage to the
device. Such damage is not covered under warranty.
1.5 Usage of external USB devices
- It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
specications, multimedia, recording and Timeshift functions of the receiver might not work
properly.*
- If you are going to use an external USB HDD (Hard Disk Drive), please consider that the
power specications may exceed the supported output of your receiver (5 V/800 mA). If so,
please connect your USB HDD to an according external power adapter.
- STRONG cannot guarantee compatibility with all types of USB storage devices.
- It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by
loss of information.
To Next Page
Loading...
