THOMSON THS210 - System Settings and Updates

23
English
Press p/q to select an option and press tu to adjust the setting. Press  to exit the menu.
Some menu items can only be entered by entering the password. Default is 0000.
Parental guidance Set the age limit for a viewer, if the viewer is underage. This only
functions if a broadcaster sends an age-signalling for the current
programme.
Set Password
Set or change the password for locked programmes and menu access. Enter your old password
or the default password '0000'. You will then be asked to enter your new password. To conrm,
re-enter your new password. After conrming, press  to exit the menu.
Restore Factory Default
Reset your receiver to the default factory settings.
Select Restore Factory Default in the main menu and press OK or u to select. Enter your
password or the default password '0000' and press OK to conrm. This option will delete all
your channels and settings. The receiver will reboot and start with the First Installation menu.
WARNING A factory reset will permanently delete all your personal settings,
timers and stored channels. Please consider this before you
perform a factory reset.
Information Read the technical details of your receiver, like model number,
Software/Hardware version and serial number. This information
could be asked during a service call or repair request.
Software update
Select Software Update in the main menu and press OK or u to select.
Download the required update le for your receiver model from the support page on our
website www.thomsonstb.net or contact your local dealer. Unzip the le on your computer,
if necessary, and copy it to root folder of your USB storage device. Connect the USB storage
device to the USB port of the receiver. Press MENU and select Software Update By USB. Press
OK to enter the software le list. Select the le containing the software image and press OK to
initiate the software update. An attention banner will now be displayed. Press OK to start the
update (or  to cancel it). Follow the instructions displayed on screen. The update process will
take some time. After the update process has been completed the receiver will restart and show
the last watched channel.
WARNING NEVER power o the receiver or remove the USB device during
the software update process. Doing so might cause irreparable
damage to your receiver and will void your warranty.
Banner on screen: Set the time-out for the info banner. Possible settings are: 3, 5, 7
seconds.