© 2013 Thorlabs GmbH
4 Programming (SDK)
271
IS_DR_DEVICE_OUT_OF_MEMORY
Not enough graphics memory available.
The DirectRenderer library could not be found.
The image memory has an inappropriate size to store the image in
the desired format.
The camera type defined in the .ini file does not match the current
camera model.
The function can not be executed in the current camera operating
mode (free run, trigger or standby).
IS_INVALID_MEMORY_POINTER
Invalid pointer or invalid memory ID
Camera is in standby mode, function not allowed
One of the submitted parameters is outside the valid range or is not
supported for this sensor or is not available in this mode.
This setting is not available for the currently set pixel clock
frequency.
An IO request from the uc480 driver failed. Possibly the versions of
the uc480_api.dll (API) and the driver file (uc480_usb.sys) do
not match.
No active image memory available. You must set the memory to
active using the is_SetImageMem() function or create a
sequence using the is_AddToSequence() function.
The camera does not contain any calibration data.
The camera model used here does not support this function or
setting.
No memory could be allocated.
IS_SEQUENCE_BUF_ALREADY_LOCKED
The memory could not be locked. The pointer to the buffer is invalid.
Function executed successfully
A timeout occurred. An image capturing process could not be
terminated within the allowable period.
The function cannot be used because the camera is waiting for a
trigger signal.