TileVision 22 - Switching the Tilevision On;Off; Selecting the On-Screen Language

23
Please allow a minimum of five seconds after switching the TileVision
®
off before switching it on
again.
English is the preset language for the TileVision
®
. The language for on-screen menus can be
selected during initial set-up or at any time in the future.
1 To switch the TileVision
®
on, press the POWER button.
The LED indicator will show green and TileVision
®
will display a picture within twenty seconds.
2 To switch the TileVision
®
to standby, press the POWER button again. The LED indicator will show red to
indicate that the TileVision
®
is in standby mode
Switching the TileVision
®
On/Off
Selecting the On-screen Language
The on-screen menus can be in any of the following twenty two languages: Český, Dansk, Deutsch, English,
Español, Ελληνικά, Français, Hrvatski, Italiano, Magyar, Nederlands, Norsk, Polski, Portugês, Pyccкий,
Româneste, Slovenščina, Srpski, Suomi, Svenska, Български, Slovak.
To change the language used follow the sequence below:
1 Press the MENU button.
2 Press the 34 buttons to display the OPTION menu.
3 Press the 56 button to highlight OSD Language.
4 Press the OK button to display the OSD Language selection menu.
5 Press the 34 or 56 buttons to highlight the required language.
6 Press the MENU button to close the menu.
All the on-screen displays will now be in the chosen language.
The selected language applies to all modes.