TileVision 22 - Auto Tuning

25
Tuning the TileVision
®
DTV / ATV
Select either DTV or ATV source see page 24
1 Press the MENU button. The CHANNEL menu will be displayed.
2 Press the 56 buttons to highlight Auto Tuning.
3 Press the OK button to display the Tuning Type menu (DVB Select Type).
4 Press the 56 buttons to highlight DVB-T / ATV.
5 Press the OK button to display the Tune Type menu.
6 Press the 34 buttons to select DTV & ATV tuning, or DTV tuning only or ATV tuning only. Once selection
has been made press the 6 button.
7 Press the 56 & 34 buttons to highlight the required country.
8 Press the OK button to start Auto Tune.
If a Sky™ box is being used as a source it should be switched on before tuning the
TileVision
®
. This will allow the TileVision
®
to tune to the Sky™ box correctly.
Select either DTV or ATV source see page 24
1 Press the MENU button. The CHANNEL menu will be displayed.
2 Press the 56 buttons to highlight Auto Tuning.
3 Press the OK button to display the Tuning Type menu (DVB Select Type).
4 Press the 56 buttons to highlight DVB-C.
5 Press the OK button to display the DVB-C Scan menu.
6 Press the 34 buttons to select Scan type between, Network Scan / Full.
6a If Scan type is set to Full, Symbol(Ks/s) can be set. If Scan type is set to Network Scan,
Frequency, Network ID and Symbol(Ks/s) can be set. Press 56 buttons to select Frequency /
Network ID / Symbol(Ks/s). Press the 34 buttons to select between Auto / enter a value. The
value is entered using the number buttons on the remote control.
7 Press the OK button to display the Tune Type menu.
8 Press the 34 buttons to select DTV & ATV tuning, or DTV tuning only or ATV tuning only. Once
selection has been made press the 6 button.
9 Press the 56 & 34 buttons to highlight the required country.
10 Press the OK button to start Auto Tune.
Tuning the TileVision
®
DVB-C