28
Tuning the TileVision
®
Satellite (Transponders)
All setup values for each satellite must be entered before selecting individual transponders.
Select Satellite source see page 24
1
Press the MENU button. The CHANNEL menu will be displayed.
2
Press the 56 buttons to highlight Dish Setup.
3
Press the OK button to display the Dish Setup menu.
4
Press the 56 buttons to highlight the required satellite.
5
Press the OK button, a RED tick will be placed by the side to indicate the satellite has been selected..
6
Edit the satellite settings if required. Refer to pages 26 & 27.
7
Press the (non waterproof remote) ECO button (GOTO Transponder). A list of transponders will be
displayed.
8
Press the 56 buttons to highlight the required transponder.
8a
Transponder values can be edited. Press the GREEN button to display the transponder edit
menu.
8b
Press the 56 buttons to highlight the required setting.
8c
The values for Frequency & Symbol(Ks/s) is entered using the number buttons on the remote
control.
8d
Press the 34 buttons to set the value for Polarity.
8e
Press the OK button to save settings and exit the transponder edit menu.
9
Press the OK button (a RED tick will be placed by the side) to select the transponder to be scanned.
10
Repeat instructions 7 & 8 to select the required transponders to be scanned.
11
Press the BLUE button, the Channel Search menu will be displayed.
Refer to page 27 to set up the Channel Search options.
To Next Page
Loading...
