Timan RC-1000 - Equipment for Rc-1000; Spikes

50
8 EQUIPMENT FOR RC-1000
You can purchase a large variety of equipment
for
RC-1000.
8.1 Spikes
Included within the optional equipment, are
spikes which can be attached to the machine for a
stronger position of the belts.
The spikes are attached between every fourth
pattern on the belt. See Figure.
Timan recommends the use of these spikes
during every drive on slopes with an inclination
greater than 35 degrees.
Push the fittings onto each side of the belt and tighten the screw.
Attach the fittings at every 4th protrusion.
One set of spikes contains:
22 spike internal fittings
22 spike external fittings
22 pcs screws M10x25
22 pcs locknuts M10
44 pcs skid plates
44 pcs rubber spikes
44 pcs screws with a countersunk head M8x12
Spare part no.: 411008