The TF100 rebox was specically
designed over many months of research
to meet the 1990 U.S.A. EPA particulate
emission standards and have been exten-
sively tested in Canadian and American
laboratories. This system is the most
efcient, simple and trouble free we know
and works as follows:
Secondary air from the front travels (along
the bottom and up the rebox sides) in
the secondary air housing to the manifold
located at the top and shoots out laterally
to oxidize the gases below the smoke exit.
The lower combustion chamber is lined
with high temperature rebricks on 2 sides,
the back and across the bottom, with a
layer of bre bafes at the top to maintain
a high temperature in the combustion
chamber so that gases mixing with the
preheated air from the secondary air mani-
fold tube are easily ignited and burned.
The appliance sides and back are shielded
to direct the heat upwards and forwards
into the room.
This appliance is EPA exempt from Phase II
prerequisites, but complies with Oregon /
Washington emissions requirements.
We suggest that our gas
hearth products be
installed and serviced by
professionals who are
certified in the U.S. by
the National Fireplace
Institute
®
(NFI) as
NFI Gas Specialists.
www.nficertified.org
THESE LOGOS AND DROP-INS MAY BE USED IN INSTRUCTION MANUALS,
PRODUCT COLLATERAL, AND ADVERTISEMENTS.
For solid fuel hearth products.
For use in
advertisements.
For gas hearth products.
We suggest that our gas
hearth products be installed
and serviced by profes-
sionals who are certified in
the U.S. by the National
Fireplace Institute
®
(NFI) as
NFI Gas Specialists.
www.nficertified.org
“SUGGEST” LINE DROP INS
We endorse
We suggest that our wood-
burning hearth products be
installed and serviced by pro-
fessionals who are certified in
the U.S. by the National
Fireplace Institute
®
(NFI) as
NFI Woodburning Specialists
or who are certified in Canada
by Wood Energy Technical
Training (WETT).
www.nficertified.org
We suggest that our pellet
hearth products be installed
and serviced by profession-
als who are certified in the
U.S. by the National
Fireplace Institute
®
(NFI) as
NFI Pellet Specialists or who
are certified in Canada by
Wood Energy Technical
Training (WETT).
www.nficertified.org
We suggest that our woodburning hearth
products be installed and serviced by
professionals who are certified in the U.S.
by the National Fireplace Institute
®
(NFI) as
NFI Woodburning Specialists or who are
certified in Canada by
Wood Energy Technical
Training (WETT).
We suggest that our pellet hearth
products be installed and serviced by
professionals who are certified in the U.S.
by the National Fireplace Institute
®
(NFI)
as NFI Pellet Specialists or who are
certified in Canada by
Wood Energy Technical
Training (WETT).
www.nficertified.org
2.4 GENERAL INFORMATION
Use of this product may produce smoke which contains chemicals known to the State of California to cause
cancer, birth defects, or other reproductive harm.
The rating plate is located on a panel, which rotates from beneath the front of the unit. The tab to locate the
rating plate panel is located below the Timberwolf logo.
2.5 CALIFORNIA PROP 65 WARNING
2.6 RATING PLATE INFORMATION
EXHAUST PATH
AIR INLET PATH
Be sure to provide sufcient combustion air. There are many other appliances in your home competing for air such
as: a kitchen range hood, forced air heating devices, clothes dryer or a bathroom exhaust fan.
After extended periods of non-operation such as following a vacation or a warm weather season, the appliance may
emit a slight odour for a few hours. This is caused by dust particles on the rebox burning off. Open a window to suf-
ciently ventilate the room.
If outside air is utilized, you should never experience a shortage of combustion air. If
you choose not to utilize outside air and experience draft or smoking problems, you may
need to open a door, a window or otherwise provide some method of supplying com-
bustion air to the appliance.
If you experience smoking problems, you may been to open a door, a window or otherwise provide some
method of supplying combustion air to the appliance.
NOTE
The rating plate must remain with the appliance at all times. It must not be removed.
W415-1133 / A / 06.12.13
7
EN