Tiny Audio C10 - Operation Controls

TINY AUDIO C10 User Guide
12
➂ Secure the Copper Stripe
Secure the Copper Strip with sticky tapes on the metal frame.
➃ Secure the Antenna Cable
Secure the antenna cable tightly down on the metal frame of the A-Pillar
with sticky tapes.
➄ Re-attach A Pillar cover
Re-attach the A Pillar cover with the antenna cable runs out of bottom of
the cover.
 Route the antenna cable
Route the antenna cable from the bottom of the A-Pillar cover within the car
interior to the DAB receiver, make sure the antenna cable does not interfere
with the safe operation of steering wheel, air bags, and seatbelts or other
equipment.
 Connect to the DAB receiver
a. Power off the DAB receiver.
b. Plug the Antenna Connector at the end of the antenna cable into DAB
receiver’s antenna input connector.
c. Power on the DAB receiver and start using your DAB receiver with the
DAB antenna.
Note:
To achieve the best performance, Antenna must not be placed over a UV
protection layer.