Toa MX-6224D User Manual (English)

Questions and Answers:

M
Ms. Megan SmithAug 12, 2025
Why is there no sound coming from my Toa Amplifier?
- S
  Steven SanchezAug 12, 2025
  Several factors could cause a lack of sound output from your Toa Amplifier. First, ensure the AC power cord is securely connected and the power switch is set to 'ON'. Check that either the 'Outside Zone' or 'Room Zone' output switch is activated. Also, verify that the volume controls are not set to the minimum. If using a microphone requiring phantom power, make sure the phantom power switch is set to 'ON', and if using MIC 2-6, connect the microphone to the XLR jack, as phantom power is not supplied to the phone jack. Overheating can also cause this issue, so remove any obstructions from the vent or adjust the amplifier volume if the speaker output is excessively loud. Finally, check for and fix any short circuits in the speaker wires.
G
Gregory ClarkAug 19, 2025
What to do if I cannot use the effector on my Toa MX-6224D?
- I
  iwilsonAug 19, 2025
  If you're unable to use the effector on your Toa Amplifier, check these settings: * Ensure the 'Effect Room Size/Delay time' selection switch is not set to 'OFF'. Choose another mode. * Make sure the effect control is set to an appropriate level, not the minimum. * If using a remote controller, verify that the effect switch on the remote controller is set to 'ON'. * If you want the sound effect to apply to the outside zone, confirm that the 'Outside Zone' output effect switch is set to 'ON'.
B
Bridget StevensAug 27, 2025
Why is the sound output from my Toa Amplifier intermittent?
- K
  Kelly OlsenAug 27, 2025
  Intermittent sound output from your Toa Amplifier can occur if a low-impedance speaker is connected to the speaker terminals. To resolve this, connect a speaker with a higher impedance than the specified rating.
K
Kristi JensenSep 4, 2025
What to do if my Toa Amplifier won't turn off with the remote?
- K
  kevincraigSep 4, 2025
  If your Toa Amplifier isn't turning off with the remote, it might be because both the 'Outside Zone' and 'Room Zone' output switches are set to 'ON'. To turn the unit off with the remote, set both of these output switches to 'OFF'.

Toa MX-6224D Specifications

General

Power Output	240 W
Frequency Response	50 Hz - 20 kHz
Total Harmonic Distortion	0.5 % (at 1 kHz, rated power)
Signal-to-Noise Ratio	80dB (line)
Power Source	AC
Input	Line
Output	Line
Tone Control	Bass, Treble
Control	Volume, Tone, Master
Indicator	Power, Signal, Clip
Operating Temperature	0°C to 40°C
Finish	black
Accessories	Power cord
Input Impedance	10 kΩ (LINE)