5-8. Ending Operation
When the set run time has elapsed, deceleration will start automatically.
The stop indicator lamp begins to ash.
※
If the key is pressed during spinning, the remaining run time is forced to set "0" and
deceleration will start.
①
②
③
STOP
When the rotor has stopped, the stop indicator lamp stays on and a "peep- peep" buzzer
sounds.
The safety interlock is released and the chamber lid can be opened.
5-9. Removing Sample Tubes
Open the chamber lid.
①
Remove sample tubes.
※
Clean rotors, buckets and racks immediately when they are exposed to such strong corrosive samples
as hydrochloric acid, sulfur and organic solvents. Please refer to "8-2. Cleaning and Disinfecting the
Rotor".
②
③
Close the lid.
To Next Page
Loading...
