8-1. Cleaning and Disinfecting the Main Unit
8. ROUTINE MAINTENANCE
Be sure to unplug the MX-307, 207 and 107 before performing
maintenance procedures.
●
Failure to do so may cause a serious electrical shock. In case of a model with no
power plug provided, turn off the power circuit breaker of the outlet to which
the power cord is connected.
Place a tray under the drain hose and remove the
drain plug to allow water to drain from the unit.
Put the plug into the drain hose after draining.
<
To drain dew condensation water out from the chamber
>
①
②
If the main unit exterior or the chamber interior becomes stained or dirty, clean or disinfect it
according to the following procedure:
Wipe the unit with a soft cloth moistened with a
neutral detergent.
Wipe away any detergent residue using a cloth
dipped in clear water and squeezed almost dry.
<
To clean the main unit
>
①
②
※
The control panel is very fragile. Be careful not
to push it hard or hit while cleaning. It may cause
damage to the panel.
※
Do not shower the chamber interior. And be careful
not to bend the temperature sensor. It may cause
malfunction.
To Next Page
