TH2883 Series Operation Manual Chapter 5 Introduction to [SETUP]
5-10
End the creation of new folder by press ENTER. If user presses ENTER
without inputting the folder name, the folder will be named as the default
name-<FOLDERxx> (xx is a number ranging from 01 to 99.). Pressing ESC
can exit the operation of creating. Letters from A to Z, numbers from 0 to 9,
and underline, etc. can be used for a file name.
Note: Users are recommended to use self-defined folder name. The
default name ranges from FOLDER01 to FOLDER 99.
Save Press this key to save a file. Move the arrow key to choose the catalog
storing the file. Press the Save soft key and then enter the file name.
Press ENTER to end this operation. If the ENTER button is pressed without
inputting the file name, the default name is FILExxx.STA (xxx ranges from
001 to 999.).
Press . , soft keys .STA, .TXT and .CSV will be displayed in the soft key
zone.
Press .STA, the file will be save as .STA file. If the file name is not
input, the file will be named as the default name FILExxx. STA (xxx
ranges from 001 to 999.).
Press .TXT, the file will be save as .TXT file. If the file name is not
input, the file will be named as the default name FILExxx. TXT (xxx
ranges from 001 to 999.).
Press .CSV, the file will be save as .CSV file. If the file name is not
input, the file will be named as the default name FILExxx. CSV (xxx
ranges from 001 to 999.).
Note: Users are recommended to use self-defined folder name. The
default name ranges from FOLDER001 to FOLDER 099.
Load Load a file saved in an external U disk. Using the arrow key or the roller can
choose the desired file. Press Load. If the selected external file is needed to
load to the internal RAM, press YES, otherwise NO.
Note: Although the instrument supports three file
formats, .STA, .TXT and CSV, only .STA file can be loaded to internal
RAM.
Delete Delete saved files. Press Delete. Then choose YES to delete the file,
otherwise NO to cancel the delete operation.
Copy to I: Copy external files (in U disk) to internal file list. Using the arrow key or the
roller can select the desired file. If the selected file is needed to copy to the
internal file list, press Copy to I: and then choose YES, otherwise choosing
NO to give up this operation. Press ENTER to end coping. In numeric input
state, press ESC to exit from this page.
Lighten this key to enable the numerical arrow key. Respectively press 8, 2, 4, 6, the
cursor will move up, down, left and right.
To Next Page
Loading...
