Tonghui TH2883-5 - 8.3.7 WADJust subsystem commands

TH2883 Series Operation Manual Chapter 8 SCPI Command reference
8-17
The [:STATe] command sets the statistic function to ON or OFF. The [:STATe]? query returns the
current state of the statistic function.
Command syntax:
ON
STATistic[:STATe] OFF
1
0
Where,
For example: WrtCmd( “STAT ON” ); turn on the statistic function.
Query syntax: STATistic[:STATe]?
Return format:<STAT><NL^END>
Where, < STAT >is as follows:
ON the statistic function is ON
OFF the statistic function is OFF
The :CLEAr command is used to clear the statistic data.
Command syntax: STATistic:CLEAr
The :SAVE command is used to save the statistic data to a file.
Command syntax: STATistic:SAVE
8.3.7 WADJust subsystem commands
The WADJust subsystem commands set the time base change and move of the waveform. Figure
8-8 shows the WADJust subsystem command tree.
Figure 8-8 Wave Adjust subsystem commands
The :MOVE command sets the move of the waveform.