Tonghui TH2883-5 - 8.3.2 IVOLTage subsystem commands

TH2883 Series Operation Manual Chapter 8 SCPI Command reference
8-6
OFF
Where,
ON the grid function is ON.
OFF the grid function is OFF.
For example: WrtCmd( “DISP:GRID ON” ); the grid display function is ON.
Query syntax: DISPlay:GRID?
Return format: <GRID STAT><NL^END>
Where, GRID STAT is as follows:
ON the grid function is ON.
OFF the grid function is OFF.
The :SECDisplay command sets the function of secondary display.
Command syntax:
DISPlay:SECDisplay ON
OFF
Where,
ON the secondary display function is ON.
OFF the secondary display function is OFF.
For example: WrtCmd( “DISP: SECD ON” ); the current secondary display function is ON.
Query syntax: DISPlay: SECD?
Return format: <GRID STAT><NL^END>
Where,
ON the secondary display function is ON.
OFF the secondary display function is OFF.
8.3.2 IVOLTage subsystem commands
The Impulse VOLTage subsystem commands set the parameters related to the impulse voltage,
including impulse voltage, impulse times, erasing impulse times, impulse voltage adjust, break
impulse voltage range and delay time. Figure 8-3 shows the Impulse VOLTage subsystem
command tree.