TH2883 Series Operation Manual Chapter 6 Introduction to [SYSTEM]
6-8
Figure 6-6 USBCDC has not been installed.
6.2.3.2 USBTMC interface
USB (Universal Serial Bus) remote control system controls the instrument through the USB
interface. This connection conforms to USBTMC-USB488 and USB2.0 protocols.
Connect USB interfaces on PC and TH2883 through a USB cable.
Install drive: The installing steps of USBTMC are the same as that of USBCDC, see 6.2.3.1 for
reference. When the installation of drive is finished, user can see “USB Test and Measurement
Devices” in the device manager of PC, as shown in figure 6-7.
To Next Page
Loading...
