7. Applied Operation and Setting of Various Functions
39
$
• While the key is pressed the auto-leveling beam shut-off will not operate.
• This mode can be used with the Remote Controller RC-60.
• When the RC-60 is used in an environment in which similar radio signals (wireless LAN, etc.)
are transmitted, and when the or key is long-pushed in step 7, the laser beam
grading may stop.
If this interferes with the operation, change the transmission channels for the RL-SV2S and
the RC-60 and try again.(C5.2 How to set remote controller communication channel(p. 24))
To Next Page
Loading...
