17
Power Switch
Turn the instrument ON or OFF by pressing the power switch on the RC-300W.
Auto-leveling and grade setting will begin.
When using the RC-300W for wireless remote control, also turn the instrument ON or OFF by
pressing the power switch on the RC-300W.
The following screen will appear if the RT-5SW did not receive the power on signal. Press the
power switch again.
The channel on the RT-5SW does not agree with that on the RC-300W (Remote mode).
1 If the channel on the main unit is different from that on the remote control when the power
switch is turned ON, the channel on the main unit will be automatically searched for.
[SEARCHING...] will be displayed.
2 When the search is finished, the available channels will be displayed. Use the arrow key (up
and down) to position the cursor on the channel you want to select and then press the [ENT]
key to establish that channel.
If the message shown left appears, it may indicate that the
radio transmission fails. Put the remote controller back to the
main unit and then turn ON the power again.
To Next Page
Loading...
Need help?
General
