19
Battery Status Display
Battery status is shown in the lower bar of the remote controller display.
When the remote controller is mounted to the RT-5SW, the battery status is for the RT-5SW only.
When the remote controller is removed from the RT-5SW, the battery status for the remote
controller is displayed. When the RT-5SW is turned on with the remote controller, the battery
status for the RT-5SW is displayed for about five seconds.
For handling batteries, see the “Handling Power sources” chapter.
Even if an AC/DC converter is connected
at this time, error display still continues.
Once the power is turned off, the battery
remaining display will reset.
Battery remaining display
RT : RT-5SW
RC : RC-300W
RT BATT LOW
or
RC BATT LOW
Battery is sufficient.
Battery is sufficient.
Battery is sufficient.
The power is low, but laser is still usable. (Indication
continues until batteries are dead.)
Dead batteries of RT-5SW or RC-300W. Recharge
the battery or replace the dry batteries with new ones.
Error display
RT BATT LOW : Dead batteries of RT-5SW
RC BATT LOW : Dead batteries of RC-300W
To Next Page
Loading...
Need help?
General
