Topcon RT-5SW - Channel Setting; Setting Channel for Attached RC-300 W; Changing Channel by Searching

35
7) Channel Setting
Set the channel of RT-5SW (only RC-300W attached to RT-5SW. In this case, the channel on
the instrument and remote controller is changed.)
1 Press the [F] key to enter Function Mode. Use the arrow key (up
and down) to select the display as shown.
2 Use the arrow key(right and left) to select the desired channel,
then press the [ENT] key to finish.
Set the channel of RC-300W (only RC-300W detached from RT-
5SW)
[Making a change directly]
1 Hold down the [F] key for 2 seconds or more to display the
channel selection screen.
2 Press the arrow key(up and down) to select [DIRECT], then
press the [ENT] key to finish.
3 Press the arrow key (up and down) to show the channel you
want to select and then press the [ENT] key to establish that
channel.
.
When using more than one units, do not use the same channel at the same time.