16
ASSEMBLY PROCEDURE
SECURING THE UNIT TYPE TABLE TOP
1 Remove the plastic washer from the unit type table top; this washer is taped to the shaft
assembly.
2 Insert the plastic washer and the shaft together into the cavity for the ophthalmic unit arm.
SECURING THE PATIENT GRIP PG-1 (OPTIONAL ACCESSORY)
1 Align the patient grip with the groove in the back of the chinrest base unit.
2 Screw the patient grip on firmly.
In the unit type table top, the power supply is fitted so that the ophthalmic unit is on
the right-hand side. When attaching the ophthalmic unit on the left-hand side,
remove the power supply and reattach it to the right-hand side (with 4 screws).
Washer
Patient grip
Chinrest base plate
Grip
To Next Page
Loading...
