Toptech MultiLoad II EXL - Multiload II 2 Output Air Eliminator Wiring

CHAPTER 5– CONNECTING FIELD DEVICES TO THE I/O BOARD
50 MultiLoad II/ RCU II Explosion Proof Lite (EXL) Installation Guide - Part # 6070
MultiLoad II 2 Output Air Eliminator Wiring
L
N
15A
I/O DIGITAL/
ANALOG
I/O 2 METER
METER 0 METER 1
PORT 2
&
PORT 3.IN/
PORT 3.OUT
PORT 2.OUT
LINE.IN
PORT 2.IN/
LINE.IN
PORT 3
IN 10
OUT 9
IN 8
OUT 7
IN 6
✓
OUT 5
✓
IN 4
✓
OUT 3
✓
IN 2
OUT 1
PORT 2
PORT 3
IO_DA TB1
PORT 0
PORT 1
PORT 8
PORT 0 OUT 5
PORT 1 OUT 4
PORT 2 OUT 3
✓
PORT 3 OUT 2
✓
LINE IN 1
✓
IO_2M TB3
PORT 0 OUT 5
PORT 1 OUT 4
PORT 2 OUT 3
✓
PORT 3 OUT 2
✓
LINE IN 1
✓
IO_2M TB2
L
N
L
N
N
L
1
2
3
Note: With only two states returned from the air eliminator,
flow must be completely stopped to purge air. To purge air
by only slowing the rate, a 3 output air eliminator head must
be used.
Note: When the level drops below Low, the power will be
removed from the digital valves, stopping flow before the air
eliminator is completely drained.