Chapter 1
5
UM10349_PCNC1100_Manual_0916A
Preface
Electrical Cabinet: Never operate the machine tool with the electrical cabinet open. Never allow
coolant pump to operate with the electrical cabinet open. Do not allow the coolant system to ow
coolant directly at the electrical cabinet or the operator panel. Neither the electrical cabinet nor the
operator panel controls are hermecally sealed against liquids.
Electrical Service: Certain service and troubleshoong operaons require access to the electrical
cabinet while power is on. Only qualied electrical technicians should perform such operaons.
Retained Electrical Power: Electronic devices within the electrical cabinet may retain dangerous
electrical voltage aer the power is o.
Support
Tormach provides no-cost technical support to our customers through mulple channels. The
quickest way to get the answers you need is normally in this order:
• Refer to operator manual rst
• Reference related documents at: hp://www.tormach.com/documents
• Email: info@tormach.com
• Phone: 608-849-8381 x2001, Monday through Friday 8 a.m. to 5 p.m. (central standard me)
• Fax: 209-885-4534
Scope and Intellectual Property
This document is intended to provide sucient informaon to allow you to install, setup, and use
your Tormach PCNC mill. It assumes that you have appropriate experience and/or access to training
for any computer-aided design/manufacturing soware to use with the mill.
Tormach Inc. is dedicated to connual improvement of its products, so suggesons for enhancements,
correcons, and claricaons are welcome.
The right to make copies of this manual is granted solely for the purpose of training courses related
to, evaluaon of, and/or use of the mill. It is not permied, under this right, for third pares to
charge for copies beyond the cost of prinng.
Every eort has been made to make this manual as complete and as accurate as possible but no
warranty or tness is claimed or implied. All informaon provided is on an as is basis. The authors,
publisher, and Tormach Inc. shall not have any liability for, or responsibility to, any person or enty
for any reason for any loss or damage arising from the informaon contained in this manual.
Tormach, PCNC 1100 Personal CNC, PCNC 770 Personal CNC, Tormach Tooling System (TTS), and
PathPilot are trademarks or registered trademarks of Tormach Inc. If other trademarks are used
in this manual, but not acknowledged, please nofy Tormach Inc. so this can be remedied in
subsequent edions. Tormach milling machines and accessories are covered by one or more of the
following U.S. Patents: 7,386,362, D606,568, D612,406, D621,859 and Patent(s) Pending.
To Next Page
Loading...
Need help?
General
