Tormach PCNC 1100 User Manual

Chapter 1
2
UM10349_PCNC1100_Manual_0916A
Preface
SAVE THESE INSTRUCTIONS!
This manual contains important safety warnings and operang instrucons for the Tormach PCNC
1100 mill. Refer to these instrucons before aempng installaon, operaon or maintenance.
Keep these instrucons together with your PCNC 1100 mill so they are readily accessible. The most
recent version of this manual is available at: www.tormach.com/tormach_product_manuals
Read Before Operating
Read and follow all warnings, cauons, and operang instrucons before operang this mill. Failure
to do so may result in voided warranty, property damage, serious injury or death.
Symbol Description Example
WARNING! Indicates a hazard which, if not
avoided, could result in death or serious injury.
WARNING! Ejection Hazard: Tools and
workpieces must be clamped properly. Failure to do
so may result in serious injury or death.
CAUTION! Indicates a hazard which, if not
avoided, could result in injury or mill damage.
CAUTION! Sharp Objects: Be sure to wear
gloves when uncrating mill. Failure to do so may
result in serious injury.
IMPORTANT!
IMPORTANT! Addresses important practices not
related to personal injury.
IMPORTANT! Damage to mill may occur if
motor weight is supported by motor wires.
NOTE:
NOTE: Provides additional information, clarication,
reminders, or helpful hints.
NOTE: For further information on automatic oiler
troubleshooting, refer to operator manual.
Safety Overview
Any machine tool is potenally dangerous. The automaon inherent in a CNC machine presents
added risk not present in a manual mill. Tormach CNC mills can deliver sucient force to break
brile tools, crush bones, and tear esh.
This manual provides guidance on safety precauons and techniques, but because the specics of
any one workshop (or other local condions) can vary greatly, Tormach accepts no responsibility for
machine performance or any damage or injury caused by its use. It is your responsibility to ensure
you understand the implicaons of what you are doing and comply with any legislaon and codes
of pracce applicable to your city, state or naon.

Tormach PCNC 1100 Specifications

General

Spindle Speed	100 - 5140 RPM
Spindle Taper	R8
Machine Type	CNC Mill
X Travel	18.0 in (457 mm)
Y Travel	9.5 inches
Z Travel	16.25 inches
Spindle Motor	1.5 hp
Voltage	220 VAC, Single Phase
Table Size	34.0 in x 9.5 in (864 mm x 241 mm)