Toro 41593 - Page 39

InstallingtheEngineHeatShield
1.Aligntherearangeoftheforwardheatshieldoverthe
forwardangeoftherearheatshield(Figure42).
Figure42
1.Frontofthemachine3.Rearange(forwardheat
shield)
2.Hex-headboltsand
washers
4.Forwardange(rearheat
shield)
2.Aligntheholesintheforwardheatshieldwiththe
threadedholesinthechassis(Figure42).
3.Assembletheforwardheatshieldtothemachinewith
the6hex-headboltsand6washers(Figure42)that
youremovedinstep4ofRemovingtheForwardHeat
Shield(page38).
4.Torquetheboltsto1129to1582N·cm(100to140
in-lb).
5.Lowerthemachineandremovethejackstands.
RemovingtheSeatBaseAccessPanel
1.Removethe2anged-headboltsthatsecuretheseat
baseaccesscovertotheseatbase(Figure43).
Figure43
1.Acousticpanel3.Flanged-headbolt
2.Seatbaseaccesscover4.Hole(seatbase)
2.Removetheseatbasecoverandtheacousticpanel
fromthemachine(Figure43).
InstallingtheSeatBaseAccessPanel
1.Aligntheacousticpaneltotheopeningintheseatbase
fortheseatbaseaccesscover(Figure43).
2.Aligntheholesintheseatbaseaccesscoverwiththe
holesintheseatbase(Figure43).
3.Assembletheseatbaseaccesscovertotheseatbase
withthe2anged-headbolts(Figure43)thatyou
removedin1inRemovingtheSeatBaseAccessPanel
(page39).
4.Torquetheboltsto1975to2542N-cm(175to225
in-lb).
39