Toro Groundsmaster 4010-D - Side Cutting Units

Figure18
4.Pushthecastorspindlethroughthefrontcastorarm.
Installtheshims(astheywereoriginallyinstalled)and
theremainingspacersontothespindleshaft.Installthe
tensioningcaptosecuretheassembly.
5.Removethehairpincotterandclevispinsecuringthe
height-of-cutchainstotherearofthecuttingunit
(Figure19).
Figure19
1.Height-of-cutchain2.Clevispinandhairpin
cotter
6.Mounttheheight-of-cutchainstothedesired
height-of-cuthole(Figure20)withtheclevispinand
hairpincotter.
Figure20
Note:Whenusing25mm(1inch),38mm(1-1/2
inch),oroccasionally51mm(2inch)height-of-cut,
movetheskidsandgagewheelstothehighestposition.
SideCuttingUnits
Toadjusttheheight-of-cutonthesidecuttingunits,add
orremoveanequalnumberofspacersfromthecastor
forks,positionthecastorwheelaxlesinthehighorlow
height-of-cutholesinthecastorforks,andsecurethepivot
armstotheselectedheight-of-cutbracketholes.
1.Positionthecastorwheelaxlesinthesameholesinall
ofthecastorforks(
Figure21andFigure23).Referto
thefollowingcharttodeterminethecorrectholefor
thesetting.
2.Removethetensioningcapfromthespindleshaft
(Figure21)andslidethespindleoutofcastorarm.Put
thetwoshims(3mm[1/8inch])ontospindleshaftas
theywereoriginallyinstalled.Theseshimsarerequired
toachievealevelacrosstheentirewidthofthecutting
units.Slidetheappropriatenumberof13mm(1/2
inch)spacersontothespindleshafttogetthedesired
height-of-cut;thenslidethewasherontotheshaft.
Figure21
1.Tensioningcap4.Toaxlemountinghole
2.Spacers5.Castorwheel
3.Shims
Refertothefollowingcharttodeterminethe
combinationsofspacersforthesetting.
Figure22
3.Pushthecastorspindlethroughthecastorarm.Install
theshims(asoriginallyinstalled)andtheremaining
28