Toro Multi Pro 5800-G - Installing the Section-Manifold Valve

InstallingtheSection-Manifold
Valve
1.Alignthe2gasketsthatyouremovedin
RemovingtheSection-ManifoldValve(page
81)totheangesofthesection-valvemanifold
(Figure119).
Note:Ifneeded,loosenthemountinghardware
fortheleftorrightsection-valvemanifoldsas
neededtoprovideclearance.
g191304
Figure119
1.Flangelocknut(1/4
inch—leftandright
section-valvemanifold
positions)
4.Flange(couplingadapter)
2.Section-bypassvalve5.Gasket
3.Quick-connecttting
(section-valvemanifold)
6.Flange-headbolt(1/4x
3/4inch—leftandright
section-valvemanifold
positions)
2.Aligntheangeofthesection-valvemanifold
betweentheangesoftheothersection-valve
(s)and/orcouplingadapter(Figure119).
3.Assemblethequick-connectttingofthe
section-valvemanifoldtothequick-disconnect
socketofthesection-bypassvalvewitha
quick-connectpin(Figure119andFigure120).
g191303
Figure120
1.Section-bypassvalve3.Quick-connectcoupler
(sectionsupplyhose)
2.Quick-connectpins4.Quick-connecttting
(agitationvalvemanifold)
4.Looselyassembletheangeclampsthatyou
removedinRemovingtheSection-Manifold
Valve(page81)totheangesofthe
section-valvemanifoldandtheangesofthe
othersection-valve(s)and/orcouplingadapter
(Figure121).
g191300
Figure121
1.Flange(couplingadapter)3.Section-manifoldvalve
2.Flange(section-manifold
valve)
4.Flangeclamps
5.Forleftorrightsection-valvemanifolds,
assemblethesection-valvemanifoldtothevalve
support(Figure119)withthe2ange-head
bolts(1/4x3/4inch)and2angelocknuts
(1/4inch)thatyouremovedinRemovingthe
Section-ManifoldValve(page81).
84