Toro Workman HDX Series - Lubrication; Greasing the Bearings and Bushings

3.Pivotthetopofthehoodforwardandunplugthe
wireconnectorsfromtheheadlights(Figure28).
4.Removethehood.
InstallingtheHood
1.Connectthelights.
2.Insertthetopmountingtabsintotheframeslots
(Figure28).
3.Insertthelowermountingtabsintotheframe
slots(Figure28).
4.Ensurethatthehoodisfullyengagedinthetop,
sides,andbottomgrooves.
Lubrication
GreasingtheBearingsand
Bushings
ServiceInterval:Every100hours(lubricate
morefrequentlyinheavy-duty
applications).
GreaseType:No.2lithiumgrease
1.Usearagtowipethegreasettingcleansothat
foreignmattercannotbeforcedintothebearing
orbushing.
2.Withagreasegun,applygreaseintothegrease
ttingsonthemachine.
3.Wipeanyexcessgreaseoffthemachine.
Important:Whengreasingthedriveshaft
universalshaftbearingcrosses,pumpgrease
untilitcomesoutofall4cupsateachcross.
Thegreasettinglocationsandquantitiesareas
follows:
•Balljoints(4);refertoFigure29
•Tierods(2);refertoFigure29
•Pivotmounts(2);refertoFigure29
•Steeringcylinder(2);refertoFigure29
g010360
Figure29
•Springtower(2);refertoFigure30
36