Toro Workman HDX Series - Adjusting the Accelerator Pedal

g009276
Figure66
1.Clutchpedal2.9.2to9.8cm(3-5/8to
3-7/8inches)
Note:Forceisappliedsothattheclutch-release
bearinglightlycontactsthepressure-plate
ngers.
4.Tightenthejamnutsafteryouattaintheproper
adjustment.
5.Checkthe9.2to9.8cm(3-5/8to3-7/8inches)
dimensionafterthejamnutshavebeen
tightenedtoensureproperadjustment.
Note:Adjustagain,ifnecessary.
6.Connectthereturnspringtotheclutchlever.
Important:Ensurethattherodendis
positionedsquarelyontheball,nottwisted,
andremainsparalleltotheclutchpedalafter
thejamnutistightened(Figure67).
Note:Theclutchfreeplayshouldneverbeless
than19mm(3/4inch).
g009277
Figure67
1.Clutch-cablerodend
3.Rodendjamnut
2.Clutchpedal
4.Parallel
AdjustingtheAccelerator
Pedal
1.Parkthemachineonalevelsurface,engagethe
parkingbrake,shutofftheengine,andremove
thekey.
2.Adjusttheballjointontheacceleratorcable
(Figure68)toallow2.54to6.35mm(0.100to
0.250inch)ofclearancebetweentheaccelerator
pedalarmandthetopofthediamondtreadoor
plate(Figure69),whenyouapply11.3kg(25lb)
offorcetothecenterofthepedal.
Note:Theenginemustnotberunningandthe
returnspringmustbeattached.
3.Tightenthelocknut(Figure68).
g019537
Figure68
1.Locknut2.Acceleratorcable
g002412
Figure69
1.2.54to6.35mm(0.100to0.250inch)clearance
Important:Themaximumhigh-idlespeedis3,650
rpm.Donotadjustthehigh-idlestop.
54