Toro Workman HDX Series - Adjusting the High-Low Cable; Adjusting Differential-Lock Cable; Inspecting the Tires

AdjustingtheHigh-Low
Cable
ServiceInterval:Every200hours
1.Removetheclevispinsecuringthehigh-low
cabletothetransaxle(Figure46).
2.Loosentheclevisjamnutandadjusttheclevis
sothattheclevisholealignswiththeholeinthe
transaxlebracket.
3.Installtheclevispinandtightenthejamnut
whennished.
AdjustingDifferential-Lock
Cable
ServiceInterval:Every200hours
1.Movethedifferential-locklevertotheOFF
position.
2.Loosenthejamnutssecuringthedifferential-lock
cabletothebracketonthetransaxle(Figure47).
g002425
Figure47
1.Differential-lockcable3.Spring
2.Transaxlebracket
4.0.25to1.5mm(0.01to
0.06inch)gap
3.Adjustthejamnutstoobtaina0.25to1.5mm
(0.01to0.06inch)gapbetweenthespringhook
andtheODoftheholeinthetransaxlelever.
4.Tightenthejamnutswhennished.
InspectingtheTires
ServiceInterval:Every100hours
Fronttiresairpressurespecication:220kPa(32
psi)
Reartiresairpressurespecication:124kPa(18
psi)
Operatingaccidents,suchashittingcurbs,can
damageatireorrimandalsodisruptwheelalignment,
soinspectthetireconditionafteranaccident.
Important:Checkthetirepressurefrequently
toensureproperination.Ifthetiresarenot
inatedtothecorrectpressure,thetireswillwear
prematurelyandmaycause4-wheeldrivetobind.
Figure48isanexampleoftirewearcausedby
under-ination.
g010294
Figure48
1.Under-inatedtire
Figure49isanexampleoftirewearcausedby
over-ination.
g010293
Figure49
1.Over-inatedtire
46